Skip to main content

You might be able to get away paying speeding fines.

From www.fines.vic.gov.au under Official Warning sub menu:

If you have received a Traffic Infringement Notice for a minor offence and you have a good driving record, you may be able to apply for an official warning.

You may apply to receive an official warning if you:

* hold a current drivers licence (including probationary licence but not including a learner drivers permit)
* have not been issued with a speeding or other traffic fine or official warning within the previous two years
* were caught doing less than 10 kilometres per hour over the speed limit
* do not deny that you were speeding.

Each application for an official warning is judged on a case-by-case basis and is subject to the discretion of Victoria Police.

To get more information about your eligibility for an official warning call Civic Compliance Victoria on (03) 9200 8111, between 8am and 6pm, Monday to Friday. Callers from regional Victoria can contact Civic Compliance Victoria on 1800 150 410 for the cost of a local call.

Other agencies have the ability to withdraw an infringement notice and issue an official warning if it is appropriate.

Comments

Popular posts from this blog

Box Hill High School Zone

Parents are struggling with moving into a good reputable school for their kid(s). Here is the zone for Box Hill High School.   Good luck with house hunting!

Venus Bay - pipi

Location: Venus Bay, Victoria This is around 2 hours drive from Melbourne. Aim for Bay 1, turn left away from the entrance; or bay 5, turn right away from the entrance. Preparation: Map (see below) Tide Time (Check at Australian Tide Time ) Fishing License (Purchase at Kmart or DPI online ) Container (2-liter per person limit) Sunscreen Drinking water NO digging tools! (hands and feet only) Fun Part – Digging: Best time is the low tide towards the lowest tide. Pipi could be around 5~10 cm deep.

Brivis Heater - Error Code #69

My Brivis HX23 Heater broke down this week.  H01 Code #69.  This code was not even listed in the User Manual!  Searching around the web and here is what I found: Secret Reset: This is not in the User Manual.  On the networker controller press FUNCTION > 1 > 4 keys and the screen will go blank and come back on after 30 seconds, this has rebooted the main PCB and reset the fault code. Use this with caution as too much gas build up could cause an explosion. Use it only after the unit has enough time to air out the gas build up. What is Code #69 or any other unpublished codes?  The best way to find out is to open up the heater unit.   There is a little LCD on the PCB showing what error exactly is. (Note: Opening up the unit may void your warranty.)