Skip to main content

Primary Schools Around Box Hill

From freedigitalphotos.net

Barloa Road
Mont Albert VIC 3127
(03) 9890 1331


Middleborough Road
Blackburn VIC 3130
(03) 9898 5811


Box Hill North Primary School‎
Elizabeth Street
Box Hill North VIC 3129
(03)9890 5023

Kerrimuir Primary‎
Molbray Street
Box Hill North VIC 3129
(03) 9898 1494

St Francis Xavier's Primary School‎
1087 Whitehorse Road
Box Hill VIC 3128
(03)9890 1108

Roberts McCubbin Primary School‎
57 Birdwood Street
Box Hill South VIC 3128
(03) 9890 2372

Surrey Hills Primary‎
Beatrice Avenue
Surrey Hills VIC 3127
(03) 9890 1560


Comments

Popular posts from this blog

Box Hill High School Zone

Parents are struggling with moving into a good reputable school for their kid(s). Here is the zone for Box Hill High School.   Good luck with house hunting!

Venus Bay - pipi

Location: Venus Bay, Victoria This is around 2 hours drive from Melbourne. Aim for Bay 1, turn left away from the entrance; or bay 5, turn right away from the entrance. Preparation: Map (see below) Tide Time (Check at Australian Tide Time ) Fishing License (Purchase at Kmart or DPI online ) Container (2-liter per person limit) Sunscreen Drinking water NO digging tools! (hands and feet only) Fun Part – Digging: Best time is the low tide towards the lowest tide. Pipi could be around 5~10 cm deep.

Brivis Heater - Error Code #69

My Brivis HX23 Heater broke down this week.  H01 Code #69.  This code was not even listed in the User Manual!  Searching around the web and here is what I found: Secret Reset: This is not in the User Manual.  On the networker controller press FUNCTION > 1 > 4 keys and the screen will go blank and come back on after 30 seconds, this has rebooted the main PCB and reset the fault code. Use this with caution as too much gas build up could cause an explosion. Use it only after the unit has enough time to air out the gas build up. What is Code #69 or any other unpublished codes?  The best way to find out is to open up the heater unit.   There is a little LCD on the PCB showing what error exactly is. (Note: Opening up the unit may void your warranty.)