Skip to main content

BILLY LIDS - Kids Play Centre


Billy Lids is an exceptional indoor children's play centre located in Hawthorn, which offers children's parties and even has a private function area with a liquor license for adult functions.
We offer a variety of activities in separate areas. All entertainment is covered by the entry fee.
Our equipment consists of the well known Billy Bugs, a mechanical ride, which seats sixteen children. There are two separate play structures - a smaller structure for under twos and a huge structure which provides a challenge for any active child with a flying fox, slides, a large ball pit and loads of tunnels to crawl and play in. We also have a jumping castle, air hockey tables, small cars, books, dress ups, a ball pit for the younger children and toys to encourage imaginative play.

We are fully heated and air-conditioned - perfect for Melbourne’s changing weather!
Monday - Friday
$10.00 per child (all children 12 months and over)
Saturday and Sunday
$11.00 per child (all children 12 months and over)
BILLY LIDS IS CLOSED ON PUBLIC HOLIDAYS

Comments

Popular posts from this blog

Box Hill High School Zone

Parents are struggling with moving into a good reputable school for their kid(s). Here is the zone for Box Hill High School.   Good luck with house hunting!

Venus Bay - pipi

Location: Venus Bay, Victoria This is around 2 hours drive from Melbourne. Aim for Bay 1, turn left away from the entrance; or bay 5, turn right away from the entrance. Preparation: Map (see below) Tide Time (Check at Australian Tide Time ) Fishing License (Purchase at Kmart or DPI online ) Container (2-liter per person limit) Sunscreen Drinking water NO digging tools! (hands and feet only) Fun Part – Digging: Best time is the low tide towards the lowest tide. Pipi could be around 5~10 cm deep.

Brivis Heater - Error Code #69

My Brivis HX23 Heater broke down this week.  H01 Code #69.  This code was not even listed in the User Manual!  Searching around the web and here is what I found: Secret Reset: This is not in the User Manual.  On the networker controller press FUNCTION > 1 > 4 keys and the screen will go blank and come back on after 30 seconds, this has rebooted the main PCB and reset the fault code. Use this with caution as too much gas build up could cause an explosion. Use it only after the unit has enough time to air out the gas build up. What is Code #69 or any other unpublished codes?  The best way to find out is to open up the heater unit.   There is a little LCD on the PCB showing what error exactly is. (Note: Opening up the unit may void your warranty.)