Skip to main content

After Hours GP Melbourne


After Hours GP is a doctor home visit service provided by the Australian Locum Medical Service to residents of metropolitan Melbourne and Perth.


All patients can access this after hours home visiting medical service if their postcode falls within our coverage area.

This house call service is bulk-billed* and there are no out of pocket costs if you are registered with Medicare or Veterans Affairs.

If medical attention is required after hours and it's not an emergency, patients or their carers may ring our call centre and request a Doctor to make a house call. Phone calls are triaged by suitably qualified and experienced staff and relayed to our doctors in the field.

Patients are telephoned by the treating doctor prior to attendance and reassured that they will be consulted in a medically appropriate timeframe.

Patients may be provided with valuable self care management advice prior to the doctor’s actual arrival and are appropriately referred to emergency services if required.

A detailed treatment report of each consultation may be forwarded to the patient’s
regular General Practitioner.


For more information, visit the web site.

Comments

Popular posts from this blog

Venus Bay - pipi

Location: Venus Bay, Victoria This is around 2 hours drive from Melbourne. Aim for Bay 1, turn left away from the entrance; or bay 5, turn right away from the entrance. Preparation: Map (see below) Tide Time (Check at Australian Tide Time ) Fishing License (Purchase at Kmart or DPI online ) Container (2-liter per person limit) Sunscreen Drinking water NO digging tools! (hands and feet only) Fun Part – Digging: Best time is the low tide towards the lowest tide. Pipi could be around 5~10 cm deep.

Box Hill High School Zone

Parents are struggling with moving into a good reputable school for their kid(s). Here is the zone for Box Hill High School.   Good luck with house hunting!

Brivis Heater - Error Code #69

My Brivis HX23 Heater broke down this week.  H01 Code #69.  This code was not even listed in the User Manual!  Searching around the web and here is what I found: Secret Reset: This is not in the User Manual.  On the networker controller press FUNCTION > 1 > 4 keys and the screen will go blank and come back on after 30 seconds, this has rebooted the main PCB and reset the fault code. Use this with caution as too much gas build up could cause an explosion. Use it only after the unit has enough time to air out the gas build up. What is Code #69 or any other unpublished codes?  The best way to find out is to open up the heater unit.   There is a little LCD on the PCB showing what error exactly is. (Note: Opening up the unit may void your warranty.)