Skip to main content

Burnt Treatment

Below are the 2 treatments I received when I got burned.  Some new techs! Here I just want to share what they are.  Seek advices from your doctor before you use them.

What is ACTICOAT?

ACTICOAT managed wounds
The ACTICOAT family consists of dressings which are flexible, absorbent and conformable and that provide an efficient and effective barrier to bacterial penetration. ACTICOAT has been shown to offer significant clinical and economic results compared to other silver dressings.

ACTICOAT has also been shown to be more effective in a chronic setting and in a comparative study.

ACTICOAT managed wounds saw a faster time to resolution of infection and also a decreased overall cost compared to competitors.


What is Silver sulfadiazine cream?

Silver sulfadiazine cream is used to prevent or to treat bacterial infections affecting your skin. It is particularly helpful in preventing burns from becoming infected. It works by killing the bacteria which are responsible for skin infections.


Labels:

Comments

Post a Comment

Popular posts from this blog

Box Hill High School Zone

Parents are struggling with moving into a good reputable school for their kid(s). Here is the zone for Box Hill High School.   Good luck with house hunting!
Post a Comment
»»»»»»»»»»»»»»»»»»» Read more »»»»»»»»»»»»»»»»»»»

Venus Bay - pipi

Location: Venus Bay, Victoria This is around 2 hours drive from Melbourne. Aim for Bay 1, turn left away from the entrance; or bay 5, turn right away from the entrance. Preparation: Map (see below) Tide Time (Check at Australian Tide Time ) Fishing License (Purchase at Kmart or DPI online ) Container (2-liter per person limit) Sunscreen Drinking water NO digging tools! (hands and feet only) Fun Part – Digging: Best time is the low tide towards the lowest tide. Pipi could be around 5~10 cm deep.
1 comment
»»»»»»»»»»»»»»»»»»» Read more »»»»»»»»»»»»»»»»»»»

Brivis Heater - Error Code #69

My Brivis HX23 Heater broke down this week.  H01 Code #69.  This code was not even listed in the User Manual!  Searching around the web and here is what I found: Secret Reset: This is not in the User Manual.  On the networker controller press FUNCTION > 1 > 4 keys and the screen will go blank and come back on after 30 seconds, this has rebooted the main PCB and reset the fault code. Use this with caution as too much gas build up could cause an explosion. Use it only after the unit has enough time to air out the gas build up. What is Code #69 or any other unpublished codes?  The best way to find out is to open up the heater unit.   There is a little LCD on the PCB showing what error exactly is. (Note: Opening up the unit may void your warranty.)
6 comments
»»»»»»»»»»»»»»»»»»» Read more »»»»»»»»»»»»»»»»»»»