Skip to main content

my5 at Coles

Here’s how it works:

  • You can choose your my5’s from over 800 Product Groups.
  • Select all 5 Product Groups to activate your my5 discount. Your my5 discount will be active within 3 days -  remember to swipe your flybuys card at the time of purchase.
  • Purchase up to 5 items from your selected Product Groups per day.
  • Your my5 discount is available until 31 October 2012.
 See flybuys for details.

To utilize my5 to low your grocery cost, you want to choose high-cost items as your my5.
This is the great news for parents with baby.  Personally, I choose nappy, formula, etc.

Higgues nappy bulk size with two boxes, you would trigger the discount and get them 10% off.  At $33 a box at the moment, it would be reduced to $29.70.  That is cheaper than Costco.
Labels:
Location: Australia

Comments

Post a Comment

Popular posts from this blog

Box Hill High School Zone

Parents are struggling with moving into a good reputable school for their kid(s). Here is the zone for Box Hill High School.   Good luck with house hunting!
Post a Comment
»»»»»»»»»»»»»»»»»»» Read more »»»»»»»»»»»»»»»»»»»

Venus Bay - pipi

Location: Venus Bay, Victoria This is around 2 hours drive from Melbourne. Aim for Bay 1, turn left away from the entrance; or bay 5, turn right away from the entrance. Preparation: Map (see below) Tide Time (Check at Australian Tide Time ) Fishing License (Purchase at Kmart or DPI online ) Container (2-liter per person limit) Sunscreen Drinking water NO digging tools! (hands and feet only) Fun Part – Digging: Best time is the low tide towards the lowest tide. Pipi could be around 5~10 cm deep.
1 comment
»»»»»»»»»»»»»»»»»»» Read more »»»»»»»»»»»»»»»»»»»

Brivis Heater - Error Code #69

My Brivis HX23 Heater broke down this week.  H01 Code #69.  This code was not even listed in the User Manual!  Searching around the web and here is what I found: Secret Reset: This is not in the User Manual.  On the networker controller press FUNCTION > 1 > 4 keys and the screen will go blank and come back on after 30 seconds, this has rebooted the main PCB and reset the fault code. Use this with caution as too much gas build up could cause an explosion. Use it only after the unit has enough time to air out the gas build up. What is Code #69 or any other unpublished codes?  The best way to find out is to open up the heater unit.   There is a little LCD on the PCB showing what error exactly is. (Note: Opening up the unit may void your warranty.)
6 comments
»»»»»»»»»»»»»»»»»»» Read more »»»»»»»»»»»»»»»»»»»